Descrição
Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from
Cura 4.2.1 Combing behaves differently between UM3 and S5
Cura not retracting correctly - UltiMaker Cura - UltiMaker
Negative retraction extra prime amount · Issue #2667 · Ultimaker
The Best Cura Plug-ins of 2023
Travel settings
First layers K8400 - Software (Repetier & Cura) - Whadda forum
Cura for Bambu X1 and P1 Series by AmaZz0r
Extra Retraction at Start - UltiMaker Cura - UltiMaker Community
slicing - Ultimaker Cura not always telling extruder to retract
The best Ender 3 retraction settings
Ultimaker cura slices fine but on reading the gcode again through
slicing - Ultimaker Cura not always telling extruder to retract
Messy first layers - no retraction - UltiMaker Cura - UltiMaker
de
por adulto (o preço varia de acordo com o tamanho do grupo)
